2020 used pickup trucks for sale in Texas

What a 2020 pickup costs in Texas

The 2020 model-year used pickup market in Texas currently shows an average asking price of $22,740 across 4 listings, with average odometer readings around 73,198 mi. Compared with the national 2020 average of $22,212, prices in Texas are running about 2.4% higher. Pricing in line with the national average means you are shopping a healthy, liquid market — neither distressed nor inflated — and should be able to negotiate normally.

Texas sits in the South region, and that geography matters when shopping a specific model year. Truck culture is a way of life here, and the used market is by far the deepest in the country. Every configuration imaginable hits dealer lots — from base-spec work trucks to fully loaded King Ranch and Limited trims with under 30,000 miles. Diesel half-tons and three-quarter-tons are unusually plentiful, and the dry climate keeps frame corrosion to a minimum. For a 2020 truck specifically, expect roughly 60,000 mi of expected lifetime mileage as the rough national baseline — anything significantly under that is either a low-use creampuff or a reset, and anything significantly over is a working truck that should be priced accordingly. Use the average odometer figure above as your local yardstick.

The 2020 model year falls into a specific equipment generation for most major nameplates. For Ford, 2020 F-150s sit in the aluminum-body 13th-generation run that introduced lightweighting and the second-generation 3.5L EcoBoost. Ram 1500s of the same vintage straddle the DS-generation classic body and the new DT generation depending on trim. Chevrolet and GMC half-tons are the K2XX or T1XX platform depending on year cutoff. Toyota Tundras are still on the second-generation aluminum-bed platform unless you are looking at a pre-redesign truck. Knowing which generation you are buying matters more than the model year itself — shop the model index for generation-by-generation buying notes.

Specific to Texas: salt-belt corrosion is essentially nonexistent, but high-mileage drivetrains from heavy interstate commuting are common. For a 2020 truck — now 5 model years old — that inspection matters more than it would on a one- or two-year-old truck still under factory powertrain warranty. Frame, suspension bushings, brake lines, and any aluminum-to-steel galvanic-corrosion contact points should be inspected on a lift. Pay particular attention to coolant condition (a sign of how the previous owner maintained the truck), transmission fluid (especially on 8- and 10-speed automatics), and the condition of the rear-axle pinion seal. A pre-purchase inspection from an independent shop typically runs $120-$180 in most South markets and will surface 80% of the issues that turn into expensive surprises later.

Cross-shopping adjacent model years is one of the highest-leverage moves a used-truck buyer can make. The 2019 market in Texas is typically 9% cheaper for what is often a mechanically identical truck. The 2021 market trades higher prices for lower mileage and more remaining factory warranty. If you are not locked into a specific model-year for tax or insurance reasons, run the math both ways before committing. Most buyers find that one model year on either side of their target is where the best total-cost-of-ownership math actually lives.

Once you have narrowed to two or three trucks worth driving across the state to inspect, treat the test-drive as the most important hour of the purchase. Cold-start the truck yourself before the dealer does. Listen for lifter tick on overhead-cam V8s. Drive at least 30 minutes including highway, low-speed turns from a stop, and at least one panic stop on dry pavement. A 2020 pickup with 73,198 mi on the clock has plenty of life left in it if it has been maintained — and almost no life left in it if it has not.